| Contents 1.
Contents sheet
2. A-frame sign
3. Paint pen for
non-personalized sign
4. 8 security ties
5. Two pieces of magnetic tape
6. Assembly instructions
|
A. Verify all parts are present
B. If parts missing, contact Mailbox Celebration
at 404 216 5802
C. Free A-frame from packaging carefully. If
non-personalized: Lay it open on a flat surface,
and using the paint pen add your data to both
sides. Let the sign dry for 3 hours
D. You will notice the sign is joined at the
top. Be careful not to force the sign open
beyond it's capability.
|
E. Peel off the backing of magnetic
tape to expose the adhesive and attach them to
the inside of each side, 1/2 inch above the
bottom holes.
F. Place sign over the mailbox and use the
magnetic strips to steady the
position. Match the holes in the sides of
the sign to the holes nearest on the mailbox.*
The length of the ties will enable you to use
holes that are not exactly matched up.
|
G. Secure cable ties in two
holes of each side. Trim off the excess
tie.
H. Once security ties are installed, your sign
will withstand all weather.
I. Hole at the top is for balloons if
desired.
Enjoy!!
|
